Shielded irradiators with louvers BactoSfera EKRAN Jalousie

Shielded bactericidal irradiators are designed for disinfecting premises in the presence of people. Disinfection occurs through natural air circulation through the zone of action of the bactericidal lamp radiation, resulting in viruses and bacteria dying from the absorbed dose of UV radiation. The safety of people in the disinfected room is achieved by using a screen in the irradiator, which prevents UV rays from reaching humans.

The advantage of irradiators with a louvered screen over irradiators with a solid screen is the maximum coverage of radiation action (3 parts of the room volume, its upper part).

Content

Introduction
FANS
ADDITIONAL OPEN LAMP
THREE PROGRAM MODES

The advantages of shielded irradiators with louvers BactoSfera EKRAN Jalousie are:

High efficiency of targeted use of bactericidal lamp radiation with minimal blocking of rays. The unique design of the housing allows the use of bactericidal lamp radiation not only in the horizontal direction but also in the vertical direction with 100% targeted efficiency, due to the open upper part of the housing, increasing the speed and efficiency of disinfection several times.
The unique design of the louver screen allows the rays to be screened so that the lower limit of the direct radiation zone runs parallel to the floor, ensuring safe presence of people in the lower part of the room.
The louver screen is made of material covered with a special matte black paint, the coating of which absorbs UV rays to the maximum, preventing their reflection into the lower part of the room.
Safety of operation and ease of installation without the need for any adjustments to the louvers or tilt of the housing: it is sufficient to comply with 2 basic safety requirements - installing the irradiator at a height of at least 2.2 meters from the floor and at a 90° angle to the wall.

BactoSfera EKRAN Jalousie have super-efficient functionality in their series of models:

FANS

Accelerated disinfection achieved by forced air circulation along the lamp using two fans.
High efficiency even in rooms with stagnant air without natural circulation.

ADDITIONAL OPEN LAMP

Possibility of surface disinfection in the room. Safety requirement - absence of people, animals, and plants in the disinfected room. It is no secret that microorganisms live not only in the air but also on various surfaces, so this function provides comprehensive protection in the fight against viruses and bacteria both in the air and on surfaces.
BactoSfera EKRAN Jalousie is installed on a perpendicular plane (wall) at a height of at least 2.2 meters from the floor, and the lower plane of its housing should be at a 90° angle to the wall, i.e., perpendicular to it (it is recommended to check this, for example, with a builder's square).

THREE PROGRAM MODES

1 MODE	Normal Single Click ON	Turns on the top shielded lamp.
2 MODE	Double tap alternately ON-OFF-ON	Turning on the top shielded lamp and starting the program: 10 seconds delay with increasing warning beep ⇒ 30 minutes of lower open lamp with constant sound indication ⇒ automatic shutdown of the lower lamp and continued operation of the upper lamp.
3 MODE	Triple Alternate Press ON-OFF-ON-OFF-ON	Toggles the top shielded lamp and the bottom open lamp.
* To reset the mode cycle, turn off the power for 2 seconds or more. After that, the cycle of modes will start from the first one.
The mode switch is located on the illuminator wire. You can also disconnect the factory wire with a switch from the terminal block, connect the irradiator directly to the mains and use a conventional wall switch to control the modes. The electronic program module of the modes is located directly in the irradiator body and is controlled by the timing of the power supply.